You searched for Alldata - Page 4 of 5 - Tomorrows Technician
Ignition System: MIL On, Ignition Coil DTCs Set

Some 2006 Zephyr; 2006-2008 Fusion and Milan; 2007-2008 MKZ, Edge, and MKX; and 2008 Taurus, Taurus X and Sable vehicles may exhibit a malfunction indicator lamp (MIL) on with diagnostic trouble codes P0351, P0352, P0353, P0354, P0355 and/or P0356 present in the Powertrain Control Module (PCM) and with one or more damaged ignition coil-on-plug(s).

Tech Tip: FIAT 500 Rear Axle Alignment

Rear axle alignment shims are available in a kit containing two shims and replacement spindle mounting bolts. The front shim is used to correct an out of specification toe-in condition, and the rear shim is used to correct an out of specification toe-out condition.

Undercover: Deciphering a Honda Pilot Clicking Noise During Braking

Listen for one or more clicking noise from the front suspension while accelerating from a moderate stop (between normal and abrupt), or while braking.

California’s Cypress College to Host an Open House in September

The open house will showcase how the collision program utilized the money it received through the Collision Repair Education Foundation’s 2011 Solera Holding, Inc’s California Matching Makeover Grant.

Engine Series: Servicing Tips for the GM 3800 Series II Engine

The Buick 3.8L has evolved from its humble beginnings as a cheap, easy-to-build, economy motor in 1962, into one of the best pushrod motors in the universe.

Undercover: ABS Bleeding Procedures and Tips

Any time the hydraulic system is opened, air can be introduced into the lines and components. Your job is to eliminate that air.

Undercover: Grinding Out Sportage Brake Repairs

In this article, we’ll be looking at brake service on a 2002 Kia Sportage. And, within the Kia site, you’ll find everything from the theory and operation of the brake system, to the specs and information needed to make an accurate diagnosis.

Tech Tip: Subaru Noise May Cause Driver Tension

This tech tip describes a modification made to the timing belt tensioner bracket to prevent the knocking noise.

Service Advisor: Avoiding Overfilling Ford Oil Levels

The best time for determining oil level is after the oil has had sufficient drain-back time to the sump.

Service Advisor: BRAKING BAD

Fixing A GM Brake Noise