TPMS Maintenance Minute: Best-Practice Rules To Follow -

TPMS Maintenance Minute: Best-Practice Rules To Follow

Every time a stem-mounted TPMS sensor is removed from a rim or is disturbed, it must be serviced - no ifs, ands or buts. This goes for sensors that are six months old to six years old. Do not reuse seals or stems. You are not doing the customer a favor by reusing old parts.

20-TPMS-Maintenance-1-370If you want to get the maximum life of 70,000 to 100,000 miles out of a TPMS sensor, you will have to do some maintenance and follow some rules.

No Exceptions

Every time a stem-mounted TPMS sensor is removed from a rim or is disturbed, it must be serviced — no ifs, ands or buts. This goes for sensors that are six months old to six years old. Do not reuse seals or stems. You are not doing the customer a favor by reusing old parts.

Don’t Torque Twice

A leak will not be eliminated by further tightening the nut. The sealing grommets are engineered to work at a specific torque. Any torque above the specified value will cause the seal to leak, and extra force may damage the nut and stem or fracture the sensor body.

Think Outside

Every 10° F of ambient temperature will change tire pressures about 2%, or about 1 psi. So, as the seasons change, and as 70º F dips to 20º F, that could mean a difference of 5 psi and a TPMS warning light. Adjust the pressure for the temperature outside and not the temperature in the bays.

Go Outside

Just be aware that if there is interference, especially inside, moving the vehicle outside (or even sometimes another foot or two if the caliper is causing the interference) is usually enough to clear things up. Don’t let someone who’s reheating their lunch spoil your relearn procedure.

Leaks Happen

It is completely normal for air to escape the tire and rim naturally and cause as much as a 1.5 psi drop per month. This is why monthly manual service checks are essential for keeping a tire healthy.

Article courtesy Import Car.

You May Also Like

Updating Your TPMS Tools Regularly Matters

You can ensure your read is accurate by updating your tool regularly.

Courtesy of Tire Review by Yanick Leduc

Picture this: Mark, an experienced tire service technician, is on the phone with a technical support representative from his TPMS supplier, inquiring why his new sensors don’t seem to work properly with the 2019 Silverado he’s servicing.

Mark: “The truck doesn’t seem to pick up the signal from the new sensor!”

Cabin Air Filters

Cabin air filters will protect the health and well-being of the driver and passengers.

Diagnostic Procedures For Stop/Start Systems

Stop/start technology is more than just a switch wired to the brake pedal and starter.

Brake Pad Wear Sensors

Brake pad wear sensors have been around for years and continue to evolve.

Topology and Your Scan Tool

Topology influences how you access the modules with your scan tool.

Other Posts

Ride Control Diagnostics From Tire Wear Clues

Learning how to read the tire and communicate your findings is the key to ride control service.

Understanding Engine Timing- Chains, Gears and Belts

Engine timing is critical for overall performance.

Air Filters and Fuel Trims

Modern engines rely on precise airflow and oxygen sensor data for optimal performance.

Mercedes Ignition Coil Pack Diagnostics

Replacing a single coil might not be the best approach to curing an engine of a chronic misfire.