Diagnosing Catalytic Converter Problems (Video)

Diagnosing Catalytic Converter Problems (Video)

There are multiple steps to diagnosing a possible air related issued on a catalytic converter. Sponsored by AP Emissions.

CC: In our previous videos we talked about how catalytic converters work, what triggers a catalyst inefficiency code, what causes thermal damage, and catalyst poisoning and how those problems reduce the efficiency of our catalytic converter.  In this video we will discuss some diagnostic procedures for catalytic converter problems arising from issues relating to air, in our air, fuel and, spark conceptual grouping

Our first step is to do a visual inspection for worn out gaskets and vacuum leaks. Do a smoke or soap bubble test if you suspect vacuum leak but cant find it

Check your mass air flow sensor and clean or replace as needed (use a scan tool or multimeter to note quick increase from 2-7 grams per second at idle to 15-25 g/s at 2500 RPM)

Test and replace any lazy upstream oxygen or “Air/Fuel” sensors– a recent CARB emissions roadside emissions check found that half of all converter failures were due to a lazy upstream sensor.

  • Check upstream O2/AF sensor is not lazy, weak, or fouled.
  • Voltage should rise to 850 mV
  • Voltage should drop to 150mV
  • Never drop below 0
  • Voltage should switch once every 2 seconds to 5 times per second
  • Voltage rise time less than 80 ms
  • Voltage fall time should be less than 100 ms

Check upstream AF sensor

  • Add metered propane, or something highly combustible like brake cleaner into air intake to force it rich, or force a lean condition with vacuum leak downstream from MAF. In both cases you should see the sensor respond very quickly. If a sensor is lazy, it should be replaced immediately.
  • 02 and Air fuel sensors should be replaced as part of your regular maintenance and tune up schedule.

Look for and patch exhaust leaks. Common locations for exhaust leaks are near hangers, at gaskets and where two surfaces are welded together. Exhaust leaks can result in a lean air fuel mixture.

Check engine compression to make sure the pressure in combustion chamber is within spec and evenly balanced across cylinders.  

In our next video, we will be looking at catalytic converter diagnostic tips related to fuel.

This video is sponsored by AP Emissions Technologies.

You May Also Like

Road to AAPEX Season 2 EP. 8

David Sickels connects with a few industry innovators as Joe hits the road to make it to AAPEX in time.

The innovation of the Lincoln Highway wasn’t just about building roads—it was about putting them on the map. The Wyoming Historical Society notes that the abandoned routes laid down by the Union Pacific railroad from 1867 to 1869 were often the best, and sometimes the only, east-west path available when developing the Lincoln Highway. In fact, staying so close to the rail line meant that the Lincoln Highway had about 100 crossings of train tracks throughout the state.

Road to AAPEX Season 2 EP. 7

As Keene connects with the Lincoln Highway’s history, David Sickels glimpses into the future of automotive technology.

Road To AAPEX Season 2 EP. 6

It’s the unexpected moments that make a trip memorable.

Road to AAPEX Season 2 Ep. 5

See how Babcox Media’s Joe Keene prepares the Lincoln Blackwood for the road.

Vehicle Electrification: Trends and Power Solutions

We are in an era of change with vehicle mobility. This video is sponsored by The Group Training Academy.

Other Posts

Throttle-By-Wire Diagnostics

On older throttle cable systems, the carburetor or fuel injection system reacted to the throttle angle.

Catalytic Converter Replacement

Converters must be certified and labeled with the correct codes that are stamped into the shell when replacing.

Fuel Pressure Diagnostics

Direct injection pressure is measured with sensors, and the signals are used to determine pump speed and/or volume.

Diagnosing Driveability Problems

Understanding what comes out through the exhaust valve is critical to solving any emissions or driveability problem.