In this tip clip excerpt from Bob Pattengale’s training course ‘Getting to know VCI,’ Bob demonstrates the usefulness of the tool’s demonstration mode. Demonstration mode’s power lies in its capability to allow you to go anywhere in the tool just as if you were connected to the car allowing you to check ahead of time to see if your software will perform a specific function before the vehicle even arrives at your shop, saving you and the customer time and headaches.
Today’s modern engines put an even greater emphasis on unique cooling requirements. This video is part of the Group Training Academy.
It may be hard to believe, but antifreeze has been around long before the automobile. In the mid-19th century, it was used in dynamite. Â Early engine designers tried other means of cooling before antifreeze gained a foothold. Â It came to prominence during World War I when it was used in tanks and vehicles to prevent them from freezing in the battlefield.
Learn the differences between ‘wet’ and ‘dry’ e-axles. This video is sponsored by CRP Automotive.
The fuel trims are what govern what’s going on inside the engine. This video is sponsored by Auto Value and Bumper to Bumper.
This video will focus on how a product like CAT COMPLETE can improve the chances of completing the monitors faster. This video is sponsored by Rislone.
Regenerative braking helps to increase the overall efficiency and range of the EV, increasing the range of an EV by up to 20%.
PRT is a global OE supplier with more than 5,000 products available in the United States.
Learn to install PRT Heavy Duty’s gas-charged shocks for enhanced driving stability in trucks and buses.
It is always best practice to replace the thermostat on a vehicle after it has overheated. Sponsored by Auto Value and Bumper to Bumper.
The Lift and Pin is designed to simplify tensioner replacement and belt installation.
