Snow Tires And TPMS -

Snow Tires And TPMS

The decision to purchase or not purchase a second set of wheels for winter needs to be followed with questions about TPMS sensors.

snowtiresThe time to change between summer and winter tires is both a regional and personal decision. Whenever it takes place, a changeover brings with it a need for consumers to make some decisions. The decision to purchase or not purchase a second set of wheels needs to be followed with questions about TPMS sensors.

Selling a second set of TPMS sensors can be very profitable. There are also several more options for sensor service today than were available just a few years ago. Performing changeovers can decrease the time for your return on investment for the equipment you have purchased to service TPMS equipment. 

Sean MacKinnon, TIA’s director of automotive training development, strongly recommends installing new sensors for the winter tire set.

However, if a decision is made to switch OE sensors to the aftermarket winter tire wheels, MacKinnon suggests installing a new TPMS service pack to ensure proper sensor operation and an air-tight seal. “Exposure to road salt and other ice-melting chemicals takes its toll on TPMS components,” he says.

Of course, there are customers tempted to completely omit TPMS sensor installation, effectively disabling a safety feature of the vehicle. “Schrader would never recommend any consumer eliminate sensors,” Paul Wise, Schrader International’s director of product line management and marketing, emphatically states. “TPMS is a legislative-mandated, safety-enhancing, OE-based system that can save lives. It has multiple benefits, including safety fuel savings, and reduced environmental impact.”

Wise says TPMS should always be on a customer’s vehicle, regardless of if and when he or she changes over to winter tires. “The accident and fatality statistics due to low tire pressure are significant and well-documented, and they need to be shared with drivers.”

MacKinnon agrees, stating that the practice of excluding TPMS sensors from a wheel assembly during a tire changeover could be construed as a direct violation of U.S. motor vehicle safety codes.

Changeover Challenges

There can be certain difficulties with some vehicles when using the same sensors on summer and winter wheel assemblies. Wise cautions that a TPMS relearn procedure may be necessary if the same sensors are used for both tire sets, but their positions on the axles change.

As always, training for tire technicians is important. MacKinnon says TIA’s Certified Automotive Tire Service training program provides in-depth TPMS information, including sensor and service pack installation guides, relearn procedures, tools and troubleshooting.

“Using a handheld TPMS scan and programming tool, test each tire for sensor activity,” he says. “Test results will indicate if any changes are needed to the customer’s setup of the winter tires. The technician can then inform the consumer of the proper service steps that can ensure a successful changeover.”

MacKinnon reminds shops that a TPMS relearn fee is becoming more common, especially if the customer has not made a major purchase at the service location. At this time, it’s rare to find vehicles with on-board computers capable of tracking two different sets of tires’ TPMS information. This feature, however, is found on several Toyota and Lexus SUVs and minivans, according to MacKinnon.

Some replacement sensors can be fitted with rubber snap-in valve stems that provide further protection against winter road salts and materials that normally corrode aluminum valve stems.

Of course, this time of year brings more glowing TPMS warning lights, as cold temperatures cause a drop in tire pressure. MacKinnon reminds technicians to check the spare tire since an increasing number of vehicles with full-size spares are equipped with a fifth TPMS sensor.

Back to Summer

Sooner or later, the threat of snow will end, and the switch to summer tires will begin. The same changeover process will take place. The vehicle may require a system relearn, and the TPMS should be inspected depending on what type of services take place during the seasonal exchange.

If a consumer refuses the service, many locations are opting to decline the business. Should a consumer choose to buy winter wheel-and-tire assemblies and the vehicle is TPMS-equipped, the service location should require the customer to implement TPMS for the winter tire set.

Article courtesy Brake & Front End.

You May Also Like

Diesel Turbocharging Basics

There’s a reason diesels typically utilize compound turbo setups instead of twin turbochargers.

Why Real Twin Turbos Aren’t Seen on Diesel Engines

A noticeable trend in OEM vehicles, and the aftermarket that supports them, is a lack of twin-turbo systems. However, when it comes to performance spark-ignition engines, twin-turbo set ups appear to be fairly common, while in turbo diesels it is only seen on very strict OEM conditions and rarely in performance diesel conditions.

Troubleshooting Tire Vibration With Proper Wheel Balancing

Around 60% of vibration-related comebacks are due to improper wheel mounting or balancing.

CV Axle Installation Tips

CV joint shafts are typically being replaced at anywhere from 70,000 to 130,000 miles.

Reflashing Power Supplies

Trying to make do with a battery charger or jumper pack can cost you more than the price of a reflash power supply.  

Replacing Master Cylinders

The most common problems that occur in the master cylinder are wear in the piston bore and piston seal failure.

Other Posts

Battery Charging and Programming Diagnostics

Temperature changes how the battery discharges and the amount of current that can be delivered.

Spring Replacement and Engineering

The specifications for the spring and strut are linked. When one component is worn, it impacts the other.

Scan And Scope Diagnostics

Using a scan tool to communicate with different modules can confirm operation and the source of communication codes.

Guidelines To Visually Inspecting A Shock Or Strut

The first thing you need to realize is that no seal is perfect.