Whatever Happened To The Original Hemi Head?

Whatever Happened To The Original Hemi Head?

Many purists say what we think of a Hemi engine today doesn’t meet the hemisperical standards.

A hemispherical combustion chamber or “hemi-head” allows for larger valves, better spark plug placement and optimized flow by placing the valves on the side of a dome. Hemi heads have been used by many manufacturers from Desoto to Porsche. With the correct engineering, the hemispherical cylinder head can produce a ton of power, but they do have limits.

The first limiting factor in the design is limited to just two valves per cylinder. Yes, these are large valves. But, the mass of valves can limit the redline of the engine.  

A “hemi-head” allows for larger valves, better spark plug placement and optimized flow by placing the valves on the side of a dome. Hemi heads have been used by many manufacturers from Desoto to Porsche.

The second limiting factor is the complexity of the valvetrain. With cam-in-block designs, the valvetrain requires broad heads with the pushrods passing through the block at odd angles giving it very complex geometry. Even if the engine used a single overhead camshaft, rockers are required. Some engines used double camshaft designs, but this resulted in an even wider head and more power losses to drive the valvetrain.

The most famous hemispherical engines are the Desoto Fireball V8 and Chrysler Hemi. The first generation lasted from 1951 to 1957 and war revived in 1964 and went out of production in 1971. While some people say emissions and fuel economy standards killed the hemi engine, the reality for Chrysler is that it was too expensive to manufacture.

But what about the “modern” Hemi in many of today’s Dodge engines? To many experts, the engineering of the Gen III Chrysler engines just doesn’t fit the “hemispherical” design of the originals, but the engine still has plenty of power – and fans.

Article courtesy Underhood Service magazine.

You May Also Like

Understanding Differences Between Aluminum And Cast Iron

Sheer material differences aside, what are the features and benefits of aluminum and iron engine components?

It doesn’t take a rocket scientist to realize that the rising cost of raw materials and supply chain disruptions over the last few years would transform our industry. However, we never envisioned the sudden demand for billet blocks to surpass that of cast iron or aluminum. The cost of cast aluminum blocks are creeping ever closer to that of their billet counterpart, therefore the additional expense is now a reasonable and practical upgrade for our racers. 

Battery Charging and Programming Diagnostics

Temperature changes how the battery discharges and the amount of current that can be delivered.

Adapting Sensors For Changing Inputs

Let’s focus our attention today on one small facet of the technology inside modern vehicles: Adaptations.

Ignition System Do’s and Don’ts

Why do ignition systems give technicians problems when diagnosing ignition-related misfires? The answer is that some technicians use tests that might give inconclusive results or do damage to the coil or drivers inside a module.

Belt Service For Hybrid and Stop/Start Systems

Knowing how to “force start” a hybrid vehicle can be helpful if you are trying to diagnose a noise problem that involves the accessory belt drive system.

Other Posts

Fuel Pumps and Cranking

Diagnosing the problem comes down to understanding what causes a loss of fuel pressure.

BMW 4-Series Service

The 4-series does not stray far from the typical BMW engineering and operation.

Crankshaft Counterweights And Balancing

Imbalance in the engine exhibits vibration and damage. Balancing becomes critical to any engine build.

Transmission Valve Body Replacement

Learning how to perform drivetrain diagnostics and “in-the-car” repairs is important.