Timing Chain Noise

Five Timing Chain Warning Signs

Here are the top five things you should be checking to resolve a timing chain problem before it breaks.

Here are the top five things you should be checking to resolve a timing chain problem before it breaks.

1. Check the Oil Level First

If the oil pump is ingesting air due to a low oil level, the timing chain adjuster can’t properly tension the timing chain. If possible, remove the oil filler cap to inspect for engine oil sludge under the camshaft cover. If the engine is heavily sludged, it’s going to be nearly impossible to clean. In most cases, a complete engine replacement is the recommended repair.

2. Listen to the Noise

Timing chains can accumulate enough wear in the chain’s links and guides to allow the chain to rattle against the timing case. A particularly “tinny” sound might indicate a broken timing chain guide.

3. Connect Your Scan Tool

Crankshaft/camshaft correlation errors on DOHC engines can be difficult to diagnose if only one of the four camshafts on a V6 engine is out of time. In most cases, a P00XX diagnostic trouble code (DTC) will be stored in the engine control module (ECM) diagnostic memory indicating which camshaft is out of time. Hyundai also includes P00XX and P03XX codes indicating if the solenoid control systems and camshaft position sensors are working.

4. Manual or Automatic?

Manual transmission vehicles are particularly susceptible to jumping a tooth on a timing chain because many drivers develop a habit of depressing the clutch, turning the engine off and using first gear as a parking brake. In some cases, the vehicle is rolling backward when the clutch is released, which, in turn, causes the crankshaft to rotate backward and causes one or more timing gears to jump time.

5. Go to the Internet!

Use online vehicle reliability information to predict timing chain failures for the types of vehicles you service. Timing chain and guide failures are relatively common on some vehicles, even at the 100,000-mile mark. In other cases, the timing chain system might be trouble-free if engine oil specifications and change intervals are followed. Whichever way your market might go, pay attention to how the workflow through your service bays is changing because the only constant in today’s automotive service market is change itself.

Article courtesy ImportCar.

You May Also Like

Installing New Rotors

Knowing if and why there’s runout will help you reinstall a smooth braking system.

Installing new rotors without ever measuring and documenting the condition of the old rotor is like playing chicken with a comeback. Sooner rather than later, you will find a vehicle that will not be magically fixed by a new set of rotors. In fact, blindly replacing the rotors can cause you to falsely blame your parts suppliers.

Diagnosing Driveability Problems

Understanding what comes out through the exhaust valve is critical to solving any emissions or driveability problem.

Ball Joint Inspection

It’s important to remember not to miss a worn joint. If a ball joint fails, the driver loses control of the vehicle.

Electronic Throttle Body Service

On most systems, idle speed is completely controlled by the throttle plate angle.

Spark Plug Replacement

Here are some tips to follow when replacing a spark plug.

Other Posts
Dealing with Deposits to Boost Engine Life

Valvoline’s Restore and Protect fully synthetic motor oil helps both older, high-mileage vehicles (restore) and new vehicles (protect).

Transmission Fluid Hydraulics

You need to know how transmission fluid flows inside an automatic transmission.

How ADAS Systems Perform

When new technologies are applied to driver safety, a higher level of scrutiny and service is required.

Air Ride Suspension Diagnostics

The key to understanding the embedded logic of air ride systems is using service information.