Automatic Belt Tensioners Are More Than Just Springs -

Automatic Belt Tensioners Are More Than Just Springs

A worn automatic belt tensioner has consequences beyond a loose belt. When an automatic belt tensioner wears down, the belt and attached accessories will start to take an extra pounding because the tensioner can no longer dampen the power pulses of the crankshaft. The effect on these components is similar to when a car has bad shocks that slowly destroy the suspension.

Tensioner-feature
A worn automatic belt tensioner has consequences beyond a loose belt. When an automatic belt tensioner wears down, the belt and attached accessories will start to take an extra pounding because the tensioner can no longer dampen the power pulses of the crankshaft. The effect on these components is similar to when a car has bad shocks that slowly destroy the suspension.

Inside some belt tensioners, unseen to most technicians, is a dampening mechanism that absorbs shock. Excessive chattering or tensioner arm movement is not only the result of poor spring tension, but also a worn dampener. This makes the tensioner a wear part with a limited life span.

Inspection

TensionersInspect the outside of the tensioner for rust bleed seeping from inside the tensioner. This is an indication that the dampener or other internal parts have failed and metal-on-metal wear is happening.

Place a wrench on the tensioner and move the arm its entire range of motion at least three times. Feel for spring tension along with a fluid motion throughout. Any sticking or notching movement may indicate a problem with the spring or pivot bearing.
The arm should move up and down. Any lateral movement could indicate a bad bearing or spring.

Spin the pulleys. They should spin freely without bearing noise. Check for any grease seepage or smudging around the pulley bearing. Seepage indicates that the bearing seal has been compromised and grease has leaked from the bearing. The pulley bearing will begin to make noise and eventually seize if not replaced soon.

Replacement

Replacement belts must be close to the same length as the originals. Low-quality replacement belts may not be the correct length and will push the tolerances of the tensioner. A belt that is too short, for example, will cause too much tension and put higher than normal loads on the bearings inside the alternator, power steering pump and water pump. A belt that is too long (just an inch or less) may slip, make noise and wear prematurely. All of this will cause the tensioner to work harder and fail sooner.

Courtesy Underhood Service.

You May Also Like

Clutch “No Release” Problems

Poor clutch release makes it difficult to start and stop the vehicle or change gears.

Clutch Release

“No release” is probably the most common of all clutch problems. The purpose of the clutch is to couple and decouple the engine and transmission. Poor clutch release makes it difficult to start and stop the vehicle or change gears.

Common Clutch release problems

Air in a hydraulic release ­system;

Visually Inspecting A Shock Or Strut

The first thing you need to realize is that no seal is perfect.

JEEP Steering Shimmy Solution

Replacement of the steering damper with AE level or newer is recommended.

Brake Problems

Reducing brake drag on late-model vehicles is not accomplished by a single component; it takes a system.

Transmission Valve Body Service

Four basic items are necessary to start your own reprogramming ventures.

Other Posts

Fuel Pumps and Cranking

Diagnosing the problem comes down to understanding what causes a loss of fuel pressure.

ADAS and Vehicle Alignment

New vehicle ADAS features all rely on the alignment being exactly as it should be.

PCV System DTC

PCV systems control crankcase pressure.

A/C Condenser Clogs

When a compressor fails, the question for most technicians is whether to flush the condenser or replace it.