How Long Should A Water Pump Last? -

How Long Should A Water Pump Last?

The service life of most original equipment water pumps should be 100,000 miles or longer. Some cheap replacement water pumps, however, may not last 30,000 miles before they start to leak. That's why you should recommend a top-quality replacement water pump if a customer's old water pump has called it quits.

pumpThe service life of most original equipment water pumps should be 100,000 miles or longer. Some cheap replacement water pumps, however, may not last 30,000 miles before they start to leak. That’s why you should recommend a top-quality replacement water pump if a customer’s old water pump has called it quits. Several factors can shorten the life of any water pump. These include internal corrosion in the cooling system (old neglected coolant that is worn out and should have been changed), as well as cavitation wear (which can be a problem with some water pumps that have plastic impellers). The pump shaft is supported by bearings, and there is usually a ceramic seal around the shaft. Antifreeze contains lubricants for the shaft bearing, as well as corrosion inhibitors to prevent internal rust and corrosion.

But these additives eventually wear out over time. If the coolant is worn out or dirty, it will shorten the life of the water pump’s bearings and seals, as well as other cooling system components. A water pump with bad bearings may make noise and/or wobble as it turns. There should be no play or movement in the pump shaft if the pump pulley is wiggled sideways by hand when the engine is off. Coolant leaking out of the vent hole on the housing means the shaft seal has failed and the pump needs to be replaced. If an engine has been overheating, but the coolant level is full and there are no signs of coolant leaks externally or internally (such as a bad head gasket), the problem may be the water pump impeller.

Steel impellers can rust or even separate from the shaft. Plastic impellers can erode and wear down, reducing the pump’s ability to circulate coolant. Either way, a pump that isn’t pumping very well needs to be replaced. Other items a customer may need when changing a water pump include gaskets, coolant, a thermostat (recommended if the engine has overheated), and a new OHC timing belt or serpentine belt if the engine has a lot of miles on it and the water pump is driven by the timing belt or serpentine belt. All the hoses in the cooling system also should be inspected and replaced if more than 10 years old.

You May Also Like

Transmission Valve Body Service

Four basic items are necessary to start your own reprogramming ventures.

The conversation goes like this: I have been paying mobile programmers or remote access programmers (RAPs) far too long. I believe I can save money and time by doing this myself. What type of equipment is needed and what is the cost to get up and running?

Let’s find out! In a nutshell, four basic items are necessary to start your own reprogramming ventures. You may even have some of these items on hand already.

Fuel Pumps and Cranking

Diagnosing the problem comes down to understanding what causes a loss of fuel pressure.

ADAS and Vehicle Alignment

New vehicle ADAS features all rely on the alignment being exactly as it should be.

PCV System DTC

PCV systems control crankcase pressure.

A/C Condenser Clogs

When a compressor fails, the question for most technicians is whether to flush the condenser or replace it.

Other Posts

ADAS False Activation Evolution

The logic behind most ADAS warnings or corrections is to examine the plausibility of the situation.

Checking The Auxiliary Water Pump

A car or truck comes into the shop with a complaint of poor heater performance. The issue may be the auxiliary water pump.

Tech holds up heater core
It’s Got Spark!

Why can’t you trust some spark tests?

ADAS Calibration Aborts

Troubleshooting the problem comes down to knowing the failure, vehicle or fixtures.