Code P0841: Hyundai/KIA A8LR1 Transmission

Hyundai/KIA A8LR1 Transmission With Code P0841

After the transmission was installed, trouble code P0841 "Transmission Fluid Pressure Switch A Circuit Range" was logged.

Article courtesy TRANSMISSION DIGEST.

A 2012 Hyundai Genesis equipped with the A8RL1 eight-speed transmission (Figure 1) has an original complaint of harsh reverse engagement, harsh 2-3 and 4-5 upshift and a neutralization condition. Since parts for this transmission were not readily available and an aftermarket remanufactured transmission could not be found, a Hyundai factory remanufactured transmission was installed. After the transmission was installed, trouble code P0841 “Transmission Fluid Pressure Switch A Circuit Range” was logged (Figure 2). This was NOT an original complaint before transmission replacement.

Figure 1
Figure 2

Evidently, several of these factory remans were sent out with a pigtail lead missing from the Pressure Switch to the internal circuit board (Figure 3). And this is what happened to Jon from Bell Transmissions prompting this article.

Hyundai’s method to fix this problem is to program the computer so it will not look for this pressure switch signal and thereby not produce code P0841. This is their fix rather than dropping the pan and simply install the missing pigtail lead. They must have had many of these get out the door that way before discovering this oversight. Maybe a disgruntled employee? Nah, that would never happen.

Figure 3
Figure 4

Anyway, this circuit is easy enough to check should this code be set. The 9- to-12-volt wire going to this pressure switch is grounded in reverse, third, and fifth gears (Figure 4). By placing a voltmeter on this wire (Figure 5), the voltage should be observed in Park, Neutral and Drive but go to 0-volts in reverse. This obviously needs to be done with the vehicle running so care must be taken to perfume this test safely. If a voltage drop to 0 is not seen, there could more than several reasons for this. The wire from the computer to the transmission is broken, or the pigtail lead is missing, the pigtail lead is not plugged onto the pressure switch, or the pressure switch is faulty.

Figure 5
Figure 6

If you desire not to fix the problem, you could always go the Hyundai way and reprogram the TCM as per Factory TSB 14-AT-001 issued January 22, 2014 (Figure 6).

You May Also Like

Tuning Adjustable Shocks and Struts

Explore adjustable shocks & struts, their functions, and proper adjustment techniques.

When it comes to shocks and struts, there are plenty of options from budget-friendly, to OE-spec, and anything in between. But there’s another segment of the aftermarket; the performance side. Sure, not every customer is going to be interested in upgraded or adjustable shocks and struts. Most customers are perfectly happy just buying the least expensive option and driving down the road. But, there are customers out there who want to improve or change the way their vehicle drives or handles.

Air Ride Suspension Diagnostics

The key to understanding the embedded logic of air ride systems is using service information.

Brake Rotor FAQ

Here are the answers to our frequently asked questions regarding brake rotors.

Catalytic Converter Replacement

Converters must be certified and labeled with the correct codes that are stamped into the shell when replacing.

Integrated Wheel Ends

The leading cause of IWE failure is water finding its way into the vacuum lines under the hood and in the wheel well.

Other Posts

Transmission Valve Body Replacement

Learning how to perform drivetrain diagnostics and “in-the-car” repairs is important.

Axle Torque Procedures

Guessing the correct torque setting is a bad idea.

Protecting Carbon Fiber Wheels During Service

Carbon fiber wheels are so delicate, cleanliness is next to godliness when mounting and demounting them.

Updating Your TPMS Tools Regularly Matters

You can ensure your read is accurate by updating your tool regularly.