Chrysler No-Start After Being Parked

Chrysler No-Start After Being Parked

When leaving a Chrysler PT Cruiser parked for an extended period of time, it could fail to start.

MODELS

2001 Chrysler PT Cruiser, L4-2.4L, VIN B, Automatic

Problem

This vehicle was parked for several months and moved only about 50 feet once a week. The owner towed it to the shop because, the last time he tried to move it, the engine would crank but not start.

Case Details 

The technician connected a scan tool but found no diagnostic trouble codes (DTCs) or anti-theft lights. He did find that there was no spark or injector pulse, so he replaced the crankshaft position sensor. Unfortunately, that did not fix the problem, so he called ALLDATA Tech-Assist. The Tech-Assist consultant mentioned that auto shut down (ASD) relay failures are common on PT Cruisers. He sent the technician a wiring diagram to indicate where to check the (B+) voltage and ground supplies to the ignition coil, fuel injectors and PCM. The consultant advised that if those were all in good condition, then the ASD relay was likely the problem.

Confirmed Repair

The technician performed the recommended circuit tests and found all (B+) voltage and grounds were good. After replacing the ASD relay, the engine started right up and ran without any problems. Fixed! 

Courtesy of ALLDATA

You May Also Like

Diagnosing Misfires

What if there are no codes and a misfire is intermittent? This is where it gets complicated. 

What is a misfire? Is a misfire when the cylinder does not fire? Is it when the cylinder fires too soon or too late? The answer is “yes” to both questions. Some misfire complaints are a flashing check engine light, and a P0300 to P0312 diagnostic trouble code (DTC) indicates that one or more cylinders are misfiring. This is the easiest misfire to diagnose. But, what if there are no codes and a misfire is intermittent? This is where it gets complicated. 

Fuel Pressure Diagnostic Service

Use a scan tool that can look at special direct fuel injection parameters and perform bidirectional tests.

Battery Charging and Diagnostics

Here are six tips to use when diagnosing a vehicle with a dead battery. 

Diagnostic Strategies For Stop/Start Systems

This function of the power management system uses several modules to decide when the engine needs to stop and start.

How Extended Interval Oil Filters Have Improved

Over time, the oil filter can collect enough contaminants to become restricted.

Other Posts

Spark Plug Replacement

Here are some tips to follow when replacing a spark plug.

Oxygen Sensors And Catalyst Efficiency

Newer air/fuel ratio or wide-band sensors can detect a wide range of fuel conditions.

Smart Battery Management

Most modern systems will measure the internal resistance.

Understanding Underhood Parts for Hybrids

Anything that can happen to an ICE in a standard vehicle can happen to an ICE in a hybrid.