VIDEO: Packing Tapered Roller Bearings

VIDEO: Packing Tapered Roller Bearings

Andrew Markel explains the proper way to grease and pack tapered roller bearings during installation.

Andrew Markel explains the proper way to grease and pack tapered roller bearings during installation. Sponsored by Auto Value and Bumper to Bumper.

Video courtesy ImportCar.

You May Also Like

Tips For Understanding Belt Friction And Tension

Serpentine belts and automatic tensioners more than tripled belt life.

Before the serpentine belt took over, the v-belt was king. The v-belt would warn drivers that it needed service – perhaps through a sharp squeak when the air conditioning clutch engaged or a scream when they tried a sharp parking lot maneuver. If they ignored the symptoms for too long, the belt would come off the pulleys or develop a glaze that made the belt slip even more.

Visually Inspecting A Shock Or Strut

The first thing you need to realize is that no seal is perfect.

AC Condensers

The characteristics that make the parallel-flow condenser so efficient are among its major drawbacks as well.

Battery Charging and Diagnostics

Here are six tips to use when diagnosing a vehicle with a dead battery. 

Installing New Rotors

Knowing if and why there’s runout will help you reinstall a smooth braking system.

Other Posts

CV Axle Installation Tips

CV joint shafts are typically being replaced at anywhere from 70,000 to 130,000 miles.

Compressor Oil for R1234yf

Working on R-1234yf systems is not that different from the R-134a variety.

Ignition Coil Output

To see inductance inside the primary windings, use an amp probe placed around the positive wire for the ignition coil.

ADAS Calibration Aborts

Troubleshooting the problem comes down to knowing the failure, vehicle or fixtures.