Subaru Tech Tip: Washer Fluid Level Sensor Diagnostics
Understanding the inspection, diagnosis and replacement procedures for the washer fluid level sensor.
Subaru Tech Tip: Error Codes Following Wheel Bearing Hub Replacement
On the affected vehicles, improper installation of a new hub assembly may cause an ABS, cruise control and/or VDC fault code to occur.
Tech Tip: Subaru Noise May Cause Driver Tension
This tech tip describes a modification made to the timing belt tensioner bracket to prevent the knocking noise.
Subaru Eyesight Calibration
All ADAS calibration procedures should start with the same steps no matter the make or the tools used for calibration.
CV Axle Installation Tips
CV joint shafts are typically being replaced at anywhere from 70,000 to 130,000 miles.
The Top OEM And Aftermarket Turbocharger Tech Tips
In the past decade, turbochargers were installed on more cars and trucks than ever before. These are the top OEM and aftermarket tips to help you install a new turbocharger without a comeback.
2005-2009 Subaru Legacy Alignment Tips
The fourth-generation Subaru Legacy was produced from 2005-2009. It was available as both a sedan and a wagon until 2008 when the wagon was dropped. The front suspension design uses a MacPherson strut. The rear suspension is a multi-link design that changes toe and camber dynamically as the suspension and body change position.
Tech Tip: Mitsubishi TPMS Relearn Procedures
If one or more TPMS sensors have been replaced on most Mitsubishi vehicles, the new ID Âinformation has to be input directly into the system.
Under the Hood: Solving Subaru Sealing Problems
Head gasket failure has been something Subaru has struggled with to some extent since the 1980s.
NASTF Examines Ways To Close Tech Education Gaps During Spring General Meetin
In addition to the complex service-readiness topic, NASTF Chairman and President of the Equipment and Tool Institute Charlie Gorman presented “Why Automakers Should Support Aftermarket Telematics,”