VIDEO: Parking Brake Cable Integrity

VIDEO: Parking Brake Cable Integrity

Andrew Markel reflects on the first time he saw a parking brake cable fail, and stresses the importance of checking on this item during every brake job.

Andrew Markel reflects on the first time he saw a parking brake cable fail, and stresses the importance of checking on this item during every brake job. Sponsored by Auto Value and Bumper to Bumper.

 

Did you Know?

• The parking or emergency brake has to perform two distinct jobs. First, it must be able to hold the vehicle on an incline. Second, it must be able to stop a vehicle under a specific distance if the hydraulic brakes have failed. These standards are set by the Department of Transportation, and the kicker is these jobs must be accomplished by the force applied by a little old lady.

• Most modern brake cables have an inner wire that is made of stainless steel and is surrounded by an outer nylon sheath. Some cables have a dry lubricant inside to prevent binding. If you are inspecting brake cables, make sure all of the grommets and boots are in place.

• The best way to keep a brake cable moving freely is to leave it alone. Many home remedies can actually shorten the life of the cable. Lubricants and oils can attract grime that can be pulled into the housing. Solvents sprayed on the cables can wash the grime further into the sheathing and can destroy the cable.

• On most vehicles, the left and right parking brake cables come together and are attached to a lever linkage called an “equalizer” yoke under the vehicle. The equalizer yoke balances, or equalizes, the amount of force that is applied to both cables when the parking brake is engaged. The equalizer linkage, in turn, is connected to a single cable that runs to the parking brake lever or pedal. An adjustment screw may be located on the front cable where it connects to the equalizer, or where the cable attaches to the parking brake lever.

• The equalizer linkage can rust up, interfering with proper application and release. The hinge pivot can also break loose and render the parking brake useless. The typical sign of a worn hinge pivot is normal travel on the lever or pedal, but the parking brake will not hold the car on a hill.

Video courtesy Brake & Front End.

You May Also Like

JEEP Steering Shimmy Solution

Replacement of the steering damper with AE level or newer is recommended.

Wrangler 2017-Newer

If a driver complains of a shimmy in the steering wheel after hitting an irregularity in the road surface such as an expansion joint, pothole or bump. Replacement of the steering damper with AE level or newer (AE will be the last two position of the steering box part number) is recommended. Vehicles built after 4/9/2019 are equipped with the new design damper.

Brake Problems

Reducing brake drag on late-model vehicles is not accomplished by a single component; it takes a system.

Transmission Valve Body Service

Four basic items are necessary to start your own reprogramming ventures.

Fuel Pumps and Cranking

Diagnosing the problem comes down to understanding what causes a loss of fuel pressure.

ADAS and Vehicle Alignment

New vehicle ADAS features all rely on the alignment being exactly as it should be.

Other Posts

PCV System DTC

PCV systems control crankcase pressure.

A/C Condenser Clogs

When a compressor fails, the question for most technicians is whether to flush the condenser or replace it.

ADAS False Activation Evolution

The logic behind most ADAS warnings or corrections is to examine the plausibility of the situation.

Checking The Auxiliary Water Pump

A car or truck comes into the shop with a complaint of poor heater performance. The issue may be the auxiliary water pump.

Tech holds up heater core