Ford Explorer Rear Toe Link Corrosion Problems And Failures

Ford Explorer Rear Toe Link Corrosion Problems And Failures

A seized toe link ball joint can increase bending stresses in the toe link outboard of the turnbuckle.

Models

2013-2017 Explorer and Police Interceptor Utility Vehicles that are registered or sold in high corrosion states.

Condition

Some of the affected vehicles, sold or operated in certain traditional corrosion areas, have experienced fracture of the outboard section of the rear suspension toe link after completion of a prior recall repair. Preliminary assessment of field data indicates that the toe link ball joint (built into the knuckle) may be susceptible to seizing in certain high corrosion areas. A seized toe link ball joint can increase bending stresses in the toe link outboard of the turnbuckle. Rear toe link fracture while driving could result in unusual vehicle handling characteristics, or difficulty controlling the vehicle and may increase the risk of a crash.

Correction

Check both toe link ball joints’ integrity and, if necessary, replace the rear wheel knuckle(s), and adjust rear toe. This service must be performed on all affected vehicles at no charge to the vehicle owner.

  1. Lift the vehicle. Remove both rear wheels.
  2. Using a jack stand, support the rear suspension at ride height. Disconnect the toe link from the knuckle.
  3. Install the toe link to knuckle bolt and nut into the ball joint on the knuckle (Figure 1). Tighten the nut while holding the bolt still with a wrench, torque it to 111 Ft/lbs.
  4. Using a torque wrench, rotate the toe link to wheel knuckle bolt while keeping the ball joint straight. Do not allow the ball joint to twist (Figure 2). Note the reading on the torque wrench when the ball joint begins to rotate.
  5. Repeat steps 2 through 4 on the other side of the vehicle.
  6. Are the readings over 11 Ft-lbs?

a. If YES, the RH ball joint has FAILED.

  1. Remove and discard the toe link.
  2. Replace the knuckle.
  3. Replace the toe link with new bolts (Figure 3 & Figure 4).
  4. Perform an alignment.

b. If NO:

  1. Replace the toe link to wheel knuckle bolt (Figure 3).
  2. Install the toe link to the knuckle with the vehicle suspension at ride height.
  3. Torque the nut to 111 Ft-lbs.
  4. Perform an alignment.

You May Also Like

BMW Driveshaft Q&A

Here are the top questions technicians ask about BMW driveshafts.

Part of BMW’s DNA is a longitudinally mounted engine and transmission connected to a rear differential with a driveshaft. Over the past 50 years, the designs of these driveshafts have changed with the different chassis and platforms. If you look at the different models you can see several types of joints, support bearings and flex discs. The only consistency is that one day the shaft will fail in a manner that will cause the customer to notice noise and maybe vibration.

Tuning Adjustable Shocks and Struts

Explore adjustable shocks & struts, their functions, and proper adjustment techniques.

Air Ride Suspension Diagnostics

The key to understanding the embedded logic of air ride systems is using service information.

Brake Rotor FAQ

Here are the answers to our frequently asked questions regarding brake rotors.

Catalytic Converter Replacement

Converters must be certified and labeled with the correct codes that are stamped into the shell when replacing.

Other Posts

Ford Maverick Hybrid With Grabby Brakes and DTC P0402

To correct this condition, reprogram various modules one module at a time.

Integrated Wheel Ends

The leading cause of IWE failure is water finding its way into the vacuum lines under the hood and in the wheel well.

Axle Torque Procedures

Guessing the correct torque setting is a bad idea.

Protecting Carbon Fiber Wheels During Service

Carbon fiber wheels are so delicate, cleanliness is next to godliness when mounting and demounting them.