You searched for Tech Tip - Page 5 of 116 - Tomorrows Technician
Tech Tip: Oil Consumption On Manual Transmission Acura Vehicles

In this updated TSB from 2013, Acura discusses how some 2011-’13 TSX models with manual transmissions can develop an oil consumption problem.

Volkswagen Tech Tip: DTC P0145 Software Update

DTC P0145 (Oxygen Sensor Circuit Bank 1-Sensor 3 Slow Response) is stored in the ECM. No other fault codes are present.

Subaru Tech Tip: Error Codes Following Wheel Bearing Hub Replacement

On the affected vehicles, improper installation of a new hub assembly may cause an ABS, cruise control and/or VDC fault code to occur.

Honda Tech Tip: Odyssey Power Sliding Door Repair Tips

Many times the trap detection logic that’s built into the power sliding door control unit can’t tell the difference between unwanted friction and something actually blocking the door’s path. To help you troubleshoot this sort of problem, we’ve put together some handy tips.

GM Tech Tip: Torque-To-Yield TTY Fastener Use And Reuse

A fastener with a torque + angle specification must be tightened first to the torque part of the specification and then tightened further by the addition of the specified angle. The angle must be applied relative to the mating fastener.

GM Tech Tip: Grease Or Sealant Visible On Electronic Power Steering Gear Is Not A Leak

On GM vehicles with electric power steering starting in 2009, you may see grease or sealant on certain locations of the steering gear

BMW Tech Tip: Oil Separator Replacement

A clogged oil separator valve is a common problem on many BMW DOHC inline sixes. The high failure rate is caused by sludge build-up that can result in oil burning, rough idle and engine fault codes.

Ford Focus Tech Tip: Wet Carpet On Passenger Side

Some 2012-2013 Focus vehicles built on or before 11/12/2012 may exhibit wet carpet on the passenger-side front foot well. This is likely due to leaking climate control condensate.

Honda Tech Tip: Oil Pressure Switch Fails Intermittently

The front and/or rear rocker arm oil pressure switch may fail intermittently.

Tech Tip: Nissan Versa EVAP Codes

Perform this service procedure if a Nissan Versa’s MIL is “ON” with with certain EVAP codes tripped, and the EVAP vent control valve is stuck open or will not seal when operated/closed.