VIDEO: Oil Pump Lost Its Prime

VIDEO: Oil Pump Lost Its Prime

Can you answer this ASE G1 test prep question? This video is sponsored by FRAM.

After an engine oil and filter service, a technician can’t get the oil pressure warning light to go out after 10 seconds of running and is not in the correct range.
What is the MOST likely cause?
A) The oil filter
B) Wrong viscosity oil installed
C) All the oil has run out of the pump
D) Air trapped in the pressure sensor

The answer is C.

Although not a common occurrence, it is very possible that the oil pump may lose its prime during the oil change. When the used motor oil is drained from the engine the oil may also drain from the oil pump pickup tube and possibly from the oil pump itself. When new motor oil is installed the pump’s pickup tube inlet again becomes submerged, trapping air in the tube on the suction side of the oil pump. Sometimes this problem can be avoided by limiting the time the oil is drained. The trapped air will cause cavitation of the pump and prevent it from producing oil flow and pressure. Many techs tend to blame this on the oil filter and assume that the filter is blocking the flow of oil. The point being made is the oil filter was not the problem and in most cases there is a simple solution.

If after the oil and filter change, the red light or low oil pressure remains for ten seconds, shut the engine off, remove the oil filter and, using an oil squirt can with the correct motor oil, squirt oil several times into the oil filter base outlet on the engine. Next, fill the filter with new motor oil and reinstall. Start the engine and check for oil pressure. In most cases, the problem will be solved. DO NOT allow the engine to run for more than ten seconds without oil pressure. Use a watch to time the ten seconds and be sure of the elapsed time. In some instances, the full ten seconds is needed for the pump to recover oil flow. If this fails, again remove the filter and crank the engine until oil spills from the engine base. DO NOT crank over ten seconds at a time. When oil spills, reinstall the oil filter, correct the oil level and restart the engine. Oil pressure should now be back to normal.

This video is sponsored by FRAM.

You May Also Like

Can You Jumpstart an EV?

First thing’s first: Find the LV battery, which could be anywhere in the vehicle.

Here’s a real-world scenario: A customer brings their EV into your shop for service, and it’s been there for quite a while because the parts are on backorder. After a few weeks, you get in the vehicle to move it out of your way, and the ignition won’t turn on. It’s acting like the battery is dead, so what do you do now?

Understanding What Antifreeze/Coolant Actually Does

Today, each manufacturer has its own formula for best results in their vehicles. This video is part of the Group Training Academy.

How The Vehicle Cooling System Functions

Here’s what to know to clarify cooling questions you’re asked at the service counter. This video is part of The Group Training Academy.

2 Wheels 2 Ways Ep. 5

Some last-minute riding out West leads the team to AIMExpo 2024 for an excellent trade show!

Not All Coolants Are Equal – Or Appropriate

Today’s modern engines put an even greater emphasis on unique cooling requirements. This video is part of the Group Training Academy.

Other Posts

Optimize Tesla Performance With E-Fluids

Learn the differences between ‘wet’ and ‘dry’ e-axles. This video is sponsored by CRP Automotive.

Understanding Fuel Trims

The fuel trims are what govern what’s going on inside the engine. This video is sponsored by Auto Value and Bumper to Bumper.

How-to Complete Emissions Monitors Faster

This video will focus on how a product like CAT COMPLETE can improve the chances of completing the monitors faster. This video is sponsored by Rislone.

How Important is Regenerative Braking For EVs?

Regenerative braking helps to increase the overall efficiency and range of the EV, increasing the range of an EV by up to 20%.